DECOSER® WALL and CEILING PANELS Decoser fiberglas reinforced plastic ( GRP ) panels are being produced with continous lamination technology by POLSER Composite Materials Corporation Decoser panels are new generation building materials which are specially engineered for buildings where minimum maintance and maximum sanitation is required.
Resistant Against Moisture
Decoser levhanın are resistant against moisture. They do not rust, corrode and do
not allow formation of mold and mildew.
Ease of Cleaning
Dirt and grease could be cleaned off easily. The panel is highly resistant against
chemicals and stains.
Tough
Decoser panels are highly resistant against impacts, scratchs and abrasion.
Easy to Install
Decoser panels could be easily drilled and cut.
Accessories
The nylon moldings and rivets are available.
|
COMMON APPLICATIONS
|
|
|
View the embedded image gallery online at:
https://polser.com/en/products/food-industry/decoser#sigProIdc2efca09d3 |
|
| TECHNICAL SPECIFICATIONS | CHEMICAL AND CORROSION RESISTANCE | ||||||||||||||||||||||||||||||||||||||||
|
Decoser sheets remain virtually unaffected in many chemical environments. It has an excellent resistance to general corrosion for surface contacts with strong chemicals. After contact with chemicals, washing the sheet's surface with sufficient amount of water would extend the life of the product.
Some of the common chemicals which Decoser sheets against are as follows:
Note: For chemicals stronger or different than above mentioned ones please contact our salesmarketing department. |
INSTALLATION
Decoser panels should only be installed over solid wall surfaces ( wood, plasterboard, etc.). Wall surfaces should be clean, flat, dry and smooth. Unsmooth wall surfaces should be made flat for best results. Liner panels will form to the contour of the wall surface when attached.Clips or caulking are recommended to hold ceiling panels in place.
STORAGE & PREPARATION
Decoser panels should be stored in a dry area. It is not recommended to store panels outdoors. Panels should be unwrapped and removed from skid and stacked on a flat, dry surface. Standard fire-safety precautions should be taken when storing and using panels.